Motion Detection Sensor is Triggered too Lately

Applies to: All Reolink IP cameras

If the motion detection sensor is always triggered too lately, the camera only records or sends notifications when the motion is already in the view or is about to go out of the view, please check the following causes and solutions:

Cause 1. Low Sensitivity

Solution: set up the sensitivity higher.

Cause 2. Inaccurate Motion Zone

Solution: set up the motion area more precisely.

Cause 3. The object is too far from the camera

Solution: adjust the angle or change a proper position for the camera to test the target place. Please refer to the article about how motion detection works.

Articles in this section

Cause 1. Low Sensitivity

Solution: set up the sensitivity higher.

Cause 2. Inaccurate Motion Zone

Solution: set up the motion area more precisely.

Cause 3. The object is too far from the camera

Solution: adjust the angle or change a proper position for the camera to test the target place. Please refer to the article about how motion detection works.

Comments

Store

Company

Social

Articles in this section

Cause 1. Low Sensitivity

Solution: set up the sensitivity higher.

Cause 2. Inaccurate Motion Zone

Solution: set up the motion area more precisely.

Cause 3. The object is too far from the camera

Solution: adjust the angle or change a proper position for the camera to test the target place. Please refer to the article about how motion detection works.

Related articles

Store

Company

Social