Applies to: Argus, Argus2, Argus3, Argus Eco, Argus PT, Argus Pro, Reolink Go, Relink Go PT, Reolink Keen
Problems: When people or objects appear in the detecting area, PIR could not be triggered immediately.
Cause1: The camera was installed too high or the installation angle of it was improper.
Solution1: Install the camera at a height of 2-3 meters above the ground. Refer to:
Cause2: The PIR sensitivity was too low.
Solution2: set up the PIR sensitivity to a higher level.
Cause3: There are glass or other obstacles between the camera and intruders.
Solution3: Change the mounting place of the camera or remove the obstacles if convenient.
Cause4: The PIR sensor is blocked by something, such as the original plastic film.
Solution4: Tear off the plastic film and make sure there is nothing blocking the PIR sensor.
Notes: If the problem still exists after the above three steps, please take down the camera and test in a closer detection distance. Or you can send the preview picture to our support team to further check the installation.