77 results for "Blue iris" in Troubleshooting

• Blue Iris Setup Failed with Reolink Device

  • 1. Reolink Support
    2. Troubleshooting
    3. 3rd party/RTSP/Other Issues
  • August 27,2024 01:24

  Symptoms on Blue Iris Setup Failed The camera cannot be detected by Blue Iris, or it fails to add after being scanned. Fix Blue Iris Setup Failed Issue 1....

• Reolink Camera Blinking Red and Blue

  • 1. Reolink Support
    2. Troubleshooting
    3. Connection issues
  • August 23,2024 09:57

  Meet any of the following criteria: The status light flashes red and blue alternately. Did you see the status light of the Reolink camera flashing red and...

• Cameras Auto Reboot Itself (E1 series and C series)

  • 1. Reolink Support
    2. Troubleshooting
    3. Reset/Reboot Issues
  • August 16,2020 11:39

  LED (Blue) ON: Power on OFF: Power off WiFi LED (Red)  Flashing: Network disconnected OFF: Network connection succeeded For C2 pro,  Status/ LED...

• Fail to Connect Reolink Lumus in LAN

  • 1. Reolink Support
    2. Troubleshooting
    3. Connection issues
  • August 07,2020 02:25

  Note: The solid blue light means that the camera is connected to WiFi; The blinking blue light means that the camera is disconnected from WiFi. When the...

• Fail to Connect E1 Series Cameras in LAN

  • 1. Reolink Support
    2. Troubleshooting
    3. Connection issues
  • August 07,2020 01:34

  Cause 2: The Camera Drops from WiFi If the status light on the front of the camera blinks in blue, it means that the camera is disconnected from WiFi. If...

• Troubleshooting Guide: Resolving Reolink Floodlight Offline Issues

  • 1. Reolink Support
    2. Troubleshooting
    3. Connection issues
  • September 18,2024 04:29

  Status Light Turns Red or Is Flashing Red/Blue: Signifies a network connection issue. Power Check: Confirm the status light is illuminated blue. If off,...

• Fail to Add Reolink WiFi Cameras

  • 1. Reolink Support
    2. Troubleshooting
    3. Setup issues
  • December 13,2018 06:54

  Please refer to Identify whether your IP camera is powered up or not For the E1 series, please check the front status led light, if you can see blue status...

• Battery-Powered Cameras Fail to Upgrade Firmware Online

  • 1. Reolink Support
    2. Troubleshooting
    3. 3rd party/RTSP/Other Issues
  • August 17,2020 10:37

  Reboot Due to Abnormal Operation Solution: You may observe whether the Status LED of the camera will flash red and blue lights alternately. If so, please...

• Failed to Connect C Series Cameras in LAN

  • 1. Reolink Support
    2. Troubleshooting
    3. Connection issues
  • August 07,2020 01:05

  If it's not solid blue, please use another DC 5V/2A power adapter to have a try. Please refer to LED Introduction for Reolink C Series Cameras for...

• Reolink Go Failed to Connect to the Network

  • 1. Reolink Support
    2. Troubleshooting
    3. Setup issues
  • December 13,2018 10:18

  Applies to: Reolink Go When you installed the SIM card and battery to the Reolink Go, the blue LED under the lens will keep turned on for about 5s and then...