You may follow the step below to reset your bullet or dome cameras to factory defaults by pressing the Reset button.

Applies to: All Reolink cameras except for battery-powered ones, E1 series, FE-P, FE-W, Video Doorbell Series, Reolink Lumus, Reolink Duo series, and TrackMix series cameras.

Note: The actual interface may vary depending on specific models.

Step 1. Power off the camera.

Step 2. Press the Reset button and hold on, then power on the camera while pressing the Reset button.


Step 3. Hold for about 10 seconds then release the Reset button.

After resetting, your camera will return to factory default settings, then you can log in with the default username (admin) and password (no password). To set a new password, check the details:

Note: For some cameras, the reset button is next to the microSD card slot.



Press the reset button for more than 5s and release it, then you will hear the reset sound to notify you reset has been operated successfully.