This article will guide you on how to initially set up Reolink 4G cameras via Reolink App.

Applies to: Reolink Go, Reolink Go PT, Reolink Go Plus, Reolink Go PT Plus, Reolink Go Ultra, Reolink Go PT Ultra, Reolink Go Ranger PT, KEEN Ranger PT, Reolink Duo 4G, Reolink Duo 2 LTE, Reolink TrackMix LTE, Reolink TrackMix LTE Plus, Reolink TrackMix Wired LTE.

If you haven’t acquired the App, scan the QR code shown below to download and install Reolink App on your iOS or Android phones.

reolink-app-qr-code__2_.jpg

Set up the Camera

Install the SIM card and power it up, then you may start the initial setup via the Reolink App when you hear the voice prompt “Network connection succeeded”. If not, please refer to the instruction to reset your camera.

If what you have is a TrackMix Wired LTE, you can choose to connect it to the router directly and set it up as a wired camera.

Note: Remember to turn on the power switch on your camera except for Reolink Go, Go Plus and Go Ultra.

Here is an initial setup video for Reolink Go and Reolink Go PT:

Here is a setup and installation video for Reolink Go Plus:

Here is a setup and installation video for Reolink Go PT Plus:

Step 1. Tap the iconAdd camera icon in the top right corner to add the camera.
1._Tap_on_Add_icon.jpg

Step 2. Scan the QR code on the back of the camera. If the phone doesn't respond, please tap Input UID/IP below the scan window, and then enter the 16-digit UID number under the QR code of the camera.

2._Scan_QR_code_on_camera.jpg2._Enter_UID.jpg

Step 3. Create the login password and name your camera, then tap Next.

create password.jpg5._Name_your_camera.jpg

Step 4. Select a scene according to the place where your camera will be installed. Then tap Next.

6._Select_a_scene.jpg

Note: Currently, only Reolink Go Plus, Go PT Plus, KEEN Ranger PT and Duo 2 LTE have the scene selection option.

Step 5. Read the note and then tap Finish to complete the initialization of your camera.

7.__Note of device initialization.jpg8._Initialization_finished.jpg

Now the initialization is finished, and you can move it to the position you want. Here is how to choose a good position for the camera.