Applies to: Reolink battery-powered cameras
If keep hearing “Please run Reolink App, add the camera, and set it up” instead of moving on to the next step when setting up cameras, it is because the camera failed to recognize the QR code on your phone screen.
There are several possible causes for the problem:
Cause 1. Your phone is too near or too far away from the camera.
Solution: Adjust the angle and the distance to make sure that your phone screen is 90° vertical to the camera at about 20 cm (8 inches) away.
Cause 2. The camera lens is dirty and unable to get a clear image of the QR code.
Solution: Wipe the camera lens with a dry paper towel/tissue. For initial setup, you may remove the protective tape on the lens.
Cause 3. The environment is too dim for the camera to recognize the QR code.
Solution: Scan the QR code on the phone’s screen where there's enough illumination and adjust your phone screen to maximum brightness.
Cause 4. The QR code is too small for the camera to scan.
Solution: Enlarge the QR code generated on the phone or try to use a phone with screen larger than 4-inch.
Cause 5. Your phone is not working properly.
Solution: Try another phone.