With alarm delay, the camera alarm will be triggered only when the detected object stays in the detection zone longer than a set time. This article intends to guide you on how to set up alarm delay for your camera via a web browser.

Applies to: Reolink WiFi cameras and PoE cameras with smart detection (E1, E1 Pro, E Series E330, Lumus, Lumus Series E430, and cameras in NVR kit are excluded)

Step 1. Input the IP Address of your camera on a web browser and log in to your camera.

See how to find the IP address of your camera.

1._log_in_via_web_browser.png

Note: Make sure your PC is connected to the same router as your camera.

Step 2. Click the Device Settings gear icon on the top right corner.

2._click_device_settings_icon.png

Step 3. Go to the Camera > Alarm Settings page. Scroll down to find Alarm Delay. 

Slide the slider on each bar of the alarm types (Person/Vehicle/Pet; they may vary based on different camera models) to adjust the time (0-8secs) for triggering the camera alarm.

alarm_delay_on_web.png

For example, in the picture above, when a person/vehicle/pet enters the detection zone and stays for more than 5 seconds, the camera alarm will be triggered.