You may find that with client software launched, the computer makes an Alarm Beep when the alarm is triggered. It is because the Alarm beep is enabled by default on the Client software. This article will guide you to enable/disable the alarm beep.
Applies to: All Reolink cameras, NVRs, and Home Hubs (except for battery-powered cameras)
Step 1. Click the gear icon on the top right of the client to go to Client Settings page.
Step 2. Go to System Settings > Alarm Settings and then disable/enable Alarm Beep. Once enabled, you can choose the detection type according to your needs.
If you want to set up the client system, refer to How to Set up Reolink Client System Settings.
If you have any questions, click “Submit a request” below to contact the Reolink Support Team.