In this article, we've prepared an easy-to-follow guide on how to reset your camera by pressing the reset button. Please scroll down and follow the steps below.
Applies to: Reolink Go PT/Go PT Plus/Go PT Ultra/Go PT S Lite/KEEN Ranger PT/Go Ranger PT
Note: Your camera settings will be cleared after reset, and the camera will be reset back to factory default settings. You need to reinitialize your camera.
Reset Reolink Go PT/Go PT Plus/Go PT Ultra/KEEN Ranger PT/Go Ranger PT
Step 1. Open the rubber cover on the micro USB port. Turn ON the power switch button to power the camera.
Step 2. Rotate the camera lens, and open the rubber cover to find the reset hole (it is right next to the micro SD card slot). And then insert the reset needle into the reset hole of your camera.
Step 3. Press the reset hole and hold for about 5-10 seconds until you hear a kind of tone sound/short music from this camera, then release the reset button.
Step 4. Press back all the rubber covers firmly.
Done! You've successfully factory reset your camera. Also, here is a video for your reference:
Reset Reolink Go PT S Lite
The Power Button and Reset Button are the same physically, but they achieve different effects through different pressing methods.
Step 1. Power on the camera. Press and hold the power button for 3 seconds to turn on the camera. (If your camera is powered on, please skip this step.)
Step 2. Reset the camera. Press the power button three times in a row. Then you will hear a kind of tone sound/short music from this camera.
Done! You've successfully factory reset your camera.
Note: Resetting the Go PT S Lite camera will unbind it from the Reolink account. Refresh the Cloud Devices Home page in the Reolink App, and you will see that the camera has been removed. To set it up again, scan the camera’s UID or enter it manually to start the initial configuration.
If you have any questions, click “Submit a request” below to contact the Reolink Support Team.