How to Set Up Post-Record/Record Extension via Reolink NVR (New UI)

Here we'll guide you to set up post-record/record extension via NVR on the monitor.

Applies to: RLN8-410 (hardware version H3MB18/N2MB02/N3MB01/N7MB01), RLN16-410 (hardware version H3MB18/N6MB01), RLN36 and RLN12W.

Note: If you want the camera to keep recording a certain time after a motion event ends, please make sure you set an Alarm recording schedule Only for the camera.

Step 1. Click Settings > Surveillance > Record Settings.

Step 2. Click Extend recording time after a motion event ends to choose the time. Done!

Helpful？

Thanks for your feedback! You can click again to cancel and feed back again.

Yes

Sorry about that. We'll be grateful if you can provide some advice.

Thank you for your feedback. Please leave your email address so that we can get in touch with you when necessary.

I've read and understood the Terms & Conditions and Privacy Policy , and I understand that Reolink will use my personal data (email) to facilitate my authentication.

submit

You have clicked too often. Please try again tomorrow.