How to Set up Exception Buzzer for NVR (New UI)

You are able to set the NVR to buzz (beep) when any of the cameras meet an exception situation, which is sometimes an efficient way to alert you, including HDD Full, HDD Erro, Network Disconnected, IP Conflict.

Applies to: RLN8-410 (hardware version H3MB18/N2MB02/N3MB01/N7MB01), RLN16-410 (hardware version H3MB18/N6MB01), RLN36 and RLN12W.

Step 1. Go to NVR > Settings.

Step 2. Go to Surveillance > Buzzer, enable Buzzer, click Exception.

Step 3. Select the exception type you want.

Helpful？

Thanks for your feedback! You can click again to cancel and feed back again.

Yes

Sorry about that. We'll be grateful if you can provide some advice.

Thank you for your feedback. Please leave your email address so that we can get in touch with you when necessary.

I've read and understood the Terms & Conditions and Privacy Policy , and I understand that Reolink will use my personal data (email) to facilitate my authentication.

submit

You have clicked too often. Please try again tomorrow.