How to Enable/Disable IR lights via Reolink NVR (New UI)

This article will show you how to enable/disable IR lights via Reolink New UI NVR with a monitor connected.

Applies to: RLN8-410 (hardware version H3MB18/N2MB02/N3MB01/N7MB01), RLN16-410 (hardware version H3MB18/N6MB01), RLN36 and RLN12W.

To configure the Infrared Lights for your camera on Reolink NVRs, go to Settings > Camera > Audio and light > Infrared light.

Off: Infrared light won't light up in the dark.

Auto: Infrared light will light up in the dark.

Helpful？

Thanks for your feedback! You can click again to cancel and feed back again.

Yes

Sorry about that. We'll be grateful if you can provide some advice.

Thank you for your feedback. Please leave your email address so that we can get in touch with you when necessary.

I've read and understood the Terms & Conditions and Privacy Policy , and I understand that Reolink will use my personal data (email) to facilitate my authentication.

submit

You have clicked too often. Please try again tomorrow.