This article will show you how to set up smart person/vehicle detection on Reolink NVRs.

Applies to: RLN8-410 with hardware version N2MB02/H3MB18/N3MB01/N7MB01; RLN16-410 with hardware version H3MB18/N6MB01; RLN36.

If you want to set up smart person/vehicle detection for your camera via the Reolink NVR systems, you can follow the steps below.

Step 1. Log in to your NVR on a monitor, and click Settings to enter the settings page.

settings.png

Step 2. Go to Surveillance > Record > Daily Schedule

record_schedule.png

Step 3. On the Record Schedule page, choose the channel you want to set up and toggle on the switch under it. 

Under Alarm, tick the Detection Type according to your demands. For example, tick person and vehicle for smart detection recording. If you do not want to see normal motions, please do not tick Any Motion.

person_recording.png

Step 4. If you want to copy the configuration to all the other cameras, click Applies to Other Camera(s) to proceed.

Note: If you want to set up smart person/vehicle detection for the other alarm actions like push notifications and email alerts, please go back to the Surveillance page and configure the Detection Type under the Push Notification Schedule page or the Email Alert Schedule page.