Here we will guide you to set up smart person detection via Reolink NVR systems.

Applies to: RLN8-410 with hardware version N2MB02/H3MB18/N3MB01/N7MB01; RLN16-410 with hardware version H3MB18/N6MB01; RLN36.

If you only want your NVR system to record or notify you when a person is detected, you can follow the guidance below to configure person detection only for different kinds of alarm actions. 

For Recording

Steps 1. Log in to your NVR system on the monitor, and click the Settings icon to enter the settings page.

settings.png

Step 2. Go to Surveillance > Record > Daily Schedule.

record_schedule.png

Step 3. Under the alarm schedule, tick Person only. If you want to copy the configuration to the other cameras, click Applies to Other Camera(s) to proceed.

person_recording.png

For Push Notifications

Step 1. Go to Surveillance > Push Notification > Daily Schedule.

push_schedule.png

Step 2. Under alarm, tick Person only. If you want to copy the configuration to the other cameras, click Applies to Other Camera(s) to proceed.

person_omly_push.png

For Email Alerts

Step 1. Go to Surveillance > Email Alerts > Daily Schedule.

email_schedule.png

Step 2. Under alarm, tick Person only. If you want to copy the configuration to the other cameras, click Applies to Other Camera(s) to proceed.

person_only_email.png