Applies to: All Reolink cameras and NVRs.
You can add the camera or NVR to Reolink Client by automatically scanning the IP if the camera or NVR is in the same LAN with your computer, and you can refer to the following article:
Add Reolink Products on the LAN via Reolink Client (Mac)
But if the Client cannot automatically scan the IP address, you can manually enter the IP of your camera or NVR, which can be found on the router interface. You may refer to the following steps:
Step1. Click Add Device, choose IP as the register mode, then you can manually enter the IP address into the column of Host. Also input camera Name, Port, Username and password. Click OK to add the device.
Note: Please use the local IP address when the camera or NVR is connected to the same LAN with your computer. If not, you need to forward ports on the router interface and use WAN IP or DDNS to add. Please refer to this article: How to Forward Ports in Router Interface for Reolink Products
Comments
0 comments
Please sign in to leave a comment.