Here is a detailed introduction to the working modes and the status LED of Reolink 4G cameras.
Applies to: Reolink Go (with a Nano SIM card slot), Go Plus, Go PT, Go PT Plus, Go PT Ultra, Keen Ranger PT, Duo 4G, Duo 2 LTE, TrackMix LTE, TrackMix Wired LTE, TrackMix LTE Plus.
- Standby Mode: The camera is in power-saving mode; there is no live view or motions detected.
- Working Mode: The camera is running at full capacity. It enters the working status when someone is accessing the camera via Reolink software or the PIR motion sensor detects a movement.
There is a LED light in the front of the camera which indicates the camera's different statuses.
- Picture: Red LED and Blue LED.
|Voice Prompt||LED Status||Camera Status|
|Network connection succeeded.||Red LED is solid on for some seconds, then blue LED flashes quickly and stays solid on for about 5 seconds and then goes off.||Camera successfully connects to the network.|
|SIM card cannot be recognized.||Red LED is solid on for some seconds and then starts to flash.||Camera cannot recognize this SIM card.|
|The SIM card is locked with a PIN. Please disable it.||Your SIM card has a PIN.|
|Not registered on network. Please activate your SIM card and check the signal strength.||Blue LED flashes slowly, then goes off.||Camera fails to be registered to the operator network.|
|Network connection failed.||Blue LED is solid on for 2 seconds and then goes off, repeating 5 times.||Camera fails to connect to the Reolink server.|
|Data call failed. Please confirm your cellular data plan is available or import the APN Settings.||Red LED is solid on, then Blue LED flashes quickly and then goes off.||The SIM card has run out of data or APN Settings are not correct.|