You may follow the below steps to stop recording via Reolink Web Browser.
Applies to: Reolink cameras and NVRs which can support web access
Stop Recording for Reolink Cameras:
Step 1. Log in to your camera via a web browser. Click the gear icon on the top right to get to the device settings page.
Step 2. Go to Surveillance > Record. Click None and check all the grids.
Click to save the settings.
For cameras that support smart detection, go to Surveillance > Record > Schedule to toggle the switch to turn off Record.
Stop Recording for Reolink NVRs:
Step 1. Log in to your camera via a web browser. Click the gear icon on the top right to get to the device settings page.
Step 2. Go to the Surveillance > Record page. Click the blue Enable Record button to turn it off. When it turns grey, the NVR will stop recording to the HDD.
Note: If you want to stop recording just for one camera that is connected to the NVR, keep the Enable Record button blue. Scroll down the Record page to the Schedule section.
Choose the camera/channel you want, then click the Schedule button to turn it off.
If the web interface of your camera is an old version, you can refer to the steps below.
Step 1. Log in to your camera via a web browser and go to the device settings page.
Step 2. Go to Recording > Advance.
Step 3. Click None and check all the grids. Please remember to click OK to save the settings.