If you want to connect the camera via a web browser, or if you want to stream the live view of the camera using RTSP, ONVIF, or other kinds of protocol, refer to the below guides to configure the corresponding ports for the camera.

Applies to: All Reolink products except battery-powered cameras

Table of Content

1. Important Notice of Reolink Ports Settings

2. Configure Reolink Ports Settings

Important Notice of Reolink Ports Settings

1. Reolink port settings are not available for Reolink battery-powered cameras.

2. The range of the port number is 1~65535.

3. If you fail to see this page, you may reboot the camera and the router, and try again.

4. Please note that E1/Lumus does not support HTTP/HTTPS/RMTP/RSTP/ONVIF ports, E1 Pro does not support HTTP/HTTPS/RMTP ports.

5. For the cameras which can support Smart Person/Vehicle/Pet detection, you can check/uncheck the RTMP, HTTP, HTTPS, RTSP, and ONVIF ports. For the other cameras, they do not have a port switch button. If the camera fails to connect with 3rd party software, please ensure that the corresponding ports are checked.

6. Regarding the function of different ports, you can refer to this article: Which Ports Should I Forward on Router for Remote Connection

Configure Reolink Ports Settings

The following content collects the port settings of each software end. Click the corresponding software end to expand the specific instructions.

  • Reolink App

    Step 1. Tap gear icon.png at the top to camera's settings, tap the arrow at the top camera model box.

    live viewcamera's settings

    Step 2. Tap Network Information > Advanced.

    network informationadvanced

    Step 3. Enable the corresponding port and you can configure the port value if needed.

    port settings

  • Reolink Client

    Here are two videos for your reference: 

    Step 1. Launch the Reolink client, go to Device Settings > Network > Advanced > Server Settings.

    port settings

    Step 2. All the values of all ports will show up. If you change it, please click Save and remember it.

    all the port

    check the port

  • Reolink Web browser

    Here is a video for your reference:

    Step 1. Log in to your camera via a web browser. Click the gear icon on the top right to get to the device settings page.

    log-in-on-IE-browser

    Click settings icon web

    Step 2. Click Network > Advanced > Port Settings > Set Up.

    port settings new

    Step 3. The values of all the ports will show up. 

    For some of the models, the RTMP, HTTP, RTSP, and ONVIF ports are disabled by default. Enable them first before you configure the port values.

    port settings

    port settings

    If the web interface of your camera is an old version, you can refer to the steps below. 

    Step 1. Log in to your camera via a web browser and go to the device settings page. 

    Step 2. Go to Network >Advanced page, then the values of all ports will show up.

    port settings old ui

  • Reolink NVR (new UI)

    Launch NVR, go to Settings > Network > Advanced, then click Server Settings. 

    settings

    port settings

    The value of all ports will show up. And you can set up the ports as you want.

    port settings

  • Reolink NVR (Old UI)

    Launch PoE NVR, go to Network > Advanced, then click Set next to Port Settings. 

    POE-main-menu

    port settings

    The value of all ports will show up. You can set up the ports as you want.

    port settings