By setting up the object size, detection objects that are too large or too small will be filtered out and won't trigger the camera alarm.  Below is a step-by-step guide on how to configure it for your camera on the NVR monitor.

Applies to: RLN8-410 (hardware version H3MB18/N2MB02/N3MB01/N7MB01), RLN16-410 (hardware version H3MB18/N6MB01), RLN36 and RLN12W.

Step 1. Log in to your camera on the NVR monitor and enter the previewing page of your camera. Then click the Settings icon on the screen. 

 1._click_device_settings.png

Step 2. Go to Camera > Detection. Click the blue Object Size on this page.

object size new ui.png

Step 3. Create Minimum and Maximum sizes for detection objects.

  • Click the object type. You could set up object size for Person/Vehicle/Pet separately. The object type may differ according to different camera models.
  • Minimum Size: Click the mceclip0.png icon (turn it blue), then left-click your mouse and drag to draw the minimum object size (the yellow rectangle).
  • Maximum Size: Click the mceclip1.png icon (turn it blue), then left-click and drag your mouse to create the maximum object size (the blue rectangle). Please note that the maximum size must be larger than the minimum one.
  • Delete: Click the Trash Can icon to delete the drawn maximum/minimum object size. Then you can redraw them.

mininum object size.png

maximum object size.png

For example, in the pictures above, a person whose size is between yellow and blue rectangles will trigger the alarm. 

Note: It's not compulsory to set up maximum and minimum object sizes at the same time. It is your choice to draw one of them or both based on your needs.

Step 4. Click Apply if you've finished setting up the object size for each object type.

Here is a video for your reference: