How to Set up Siren via Reolink Client

If you want your camera gives an audio alarm when it detects motion, below are the steps to guide you on how to configure it via Reolink Client.

Applies to: Reolink battery-powered cameras, E1 series, C series, Reolink Lumus, B1200, D1200, RLC-523WA, RLC-511WA, RLC-811A, RLC-812A, RLC-823A, RLC-823A 16X, RLC-824A, RLC-81MA, RLC-830AM, RLC-833A, RLC-1212A, RLC-1224A, Reolink Duo series, Reolink TrackMix series

Step 1. Please launch Reolink Client and connect the camera, then go to Settings > Surveillance > Siren page. Turn on the siren option.

Step 2. For a camera with smart detection, you can set a schedule and select the detection types (which vary from camera model) to determine when and what kind of motions the camera detects could trigger the siren to go off.

Helpful？

Thanks for your feedback! You can click again to cancel and feed back again.

Yes

Sorry about that. We'll be grateful if you can provide some advice.

Thank you for your feedback. Please leave your email address so that we can get in touch with you when necessary.

I've read and understood the Terms & Conditions and Privacy Policy , and I understand that Reolink will use my personal data (email) to facilitate my authentication.

submit

You have clicked too often. Please try again tomorrow.