For remote access camera or NVR via UID, UID is necessary to be enabled. Below are the steps to guide you to enable or disable UID via Reolink Client.
Applies to: All Reolink cameras and NVRs except battery-powered cameras.
Step 1. Launch Reolink Client, then go to the Settings >Network Settings page.
Step 2. Click Advanced, then turn on or turn off the Enable UID option.
Helpful？
Thanks for your feedback! You can click again to cancel and feed back again.
Sorry about that. We'll be grateful if you can provide some advice.
Thank you for your feedback. Please leave your email address so that we can get in touch with you when necessary.
I've read and understood the Terms & Conditions and Privacy Policy , and I understand that Reolink will use my personal data (email) to facilitate my authentication.
You have clicked too often. Please try again tomorrow.
PRODUCTS
RLC-811AReolink Duo 2 PoEReolink Go PT PlusBattery CamerasDual-Lens Security CamerasPoE IP CamerasWiFi Security CamerasSecurity Camera SystemsVideo DoorbellsSolution FinderSUPPORT
Support CenterBlog3rd-Party CompatibilityPayment MethodsWarranty & ReturnShipping & DeliveryTrack Your OrderProduct RegistrationPurchase FAQsCOMPANY
About UsSecurity#ReolinkCapturesPress & MediaContact UsPrivacy PolicyTerms & ConditionsPROGRAMS
Affiliate ProgramPartner ProgramShop for Business#ReolinkTrial#ReolinkinAction