Follow the steps below to set up the stream settings such as resolution, bitrate, frame rate, I-frame Interval for the cameras that are connected to the NVR.
Applies to: RLN8-410 (hardware version H3MB18/N2MB02/N3MB01/N7MB01), RLN16-410 (hardware version H3MB18/N6MB01), RLN36 and RLN12W.
Here is a video to show how to reduce the main stream resolution of the camera on the monitor:
Step 1. Log in to the NVR and go to Setting > Camera > Stream page.
Step 2. Select the channel (Camera No.) you need and change the settings as you need. Then click Apply to Other Camera to copy the same settings to other channels.
1. For the Resolution/Frame Rate/Max. Bitrate/I-frame Interval, refer to How to Set up the Record Encode for Reolink Cameras.
2. The resolution of the recording video will also change after you set up the parameters for the camera.
3. Frame Rate Mode: If set to Auto, the device will use different frame rate in different situations. If you want it to remain the same, select Constant.
4. The features that you see might vary from device models.