How to Set up Monitor Point via Reolink Client

This article is a useful guide on how to set up the monitor point for your camera via Reolink Client.

Applies to: E1 Pro, E1 Zoom, E1 Outdoor, E1 Outdoor PoE, E1 Outdoor Pro, RLC-830A, RLC-523WA, RLC-823A, RLC-823A 16X, Reolink TrackMix, TrackMix LTE, TrackMix WiFi, TrackMix PoE, TrackMix LTE Plus, Argus PT Ultra, Go PT Ultra, RLC-81PA.

If you want the camera goes back to the default monitoring position after Pan and tilt, please refer to the below steps to set a guard point for the camera via the Reolink Client.

Step 1. Click the PTZ button on the live-view page, and use the arrows and the zoom buttons to aim your camera's view at a specific area that you want to set as a monitor position.

1.click_PTZ_icon.png

Step 2. Click Monitor Point. Click Reset Monitor Point to set the current position as the monitor point.

2.click_monitor_point.png 3._set_up_monitor_point.png

Return to Monitor Point: Click it and your camera will return to the monitor point immediately.
Auto: Enable it so that your camera will return to the monitor point after the camera stop panning or tilting.
Intervals: Time duration (10-300 seconds) between the camera stopping pan/tilt and the camera returning to the monitor point.

Note: Before the first time you set up the monitor point, you need to use Calibration.

During calibration, the PTZ function is disabled temporarily.