Applies to: All Reolink NVRs.
Please follow the steps below to save continuous recordings and alarm recordings to the NVR simultaneously on the Reolink client. After configuring the record settings and alarm settings in this way, you can see the highlighted motions on the playback timeline when you playback the recordings.
Step 1. Launch Reolink Client and log in to the NVR, then click on Device settings -> Detection.
Step 2. Choose the channel you want to configure.
Step 3. Select Motion and then click on all the grids to set up the motion detection schedule, then click to save the settings.
Step 4. Then go to Device settings-> Surveillance-> Record. Choose the channel you want to configure and select Alarm and then click on all the grids to set up the motion recording schedule.
Step 5.Choose Timer and tap on the grids to choose the periods during which you want to enable continuous recording for this camera. Click Save to save your settings.
Step 6: And if you want to set the same schedule for the other cameras, please click Apply to Other Cameras and choose the camera you want to copy the recording schedule.