Applies to: All Reolink POE NVRs and IP cameras( E1 Zoom is included) except for all Reolink battery-powered cameras, Reolink wifi nvr system, Reolink E1, Reolink E1 Pro, B400, D400, B800, D800, and Reolink Lumus
Step 1: Connect your camera to the LAN port of the router by an Ethernet cable.
- The camera needs to be powered on.
- Make sure that your PC is in the same local network with the router.
Step 2: Log in your camera via Web Browsers and go to the Device Settings page.
Step 3. Go to Alarm->Motion->Sensitivity page.
Step 4: Set the 4 time periods and corresponding sensitivity. Please do not forget to click OK to save the settings.
Note: The Sensitivity setting is controlled by a slider, allowing you to set a value between 1 to 50. The higher the numerical value is, the more sensitive the motion detection will be.
You may also configure motion sensitivity using other methods. Check details in:
Comments
0 comments
Article is closed for comments.