Applies to: All Reolink PoE NVRs.
Go to Device Settings of your NVR and find Alarm-> Motion detection->Alarm Setup, select the channel you want, check/uncheck on Audio Warning and then click on OK button.
Here is a brief introduction of other options on this page.
- Send Email: You can set up email for your device on this page, it will send you an email when motion detective.
- Push Notification: A push notification will be sent to your phone if you set the push for your NVR.
- Triggered Recording: The selected channel under Triggered Recording option will begin to record when the camera you chose in Channel option triggered by motion. This option is designed for the monitoring dead ends where cannot be covered by a single camera.
Comments
0 comments
Article is closed for comments.