Applies to: all the Reolink PoE NVRs.
If you want your device to remind you when motion detected, you can set the motion alarm for it.
Go to Device Settings of your NVR and find Motion under Alarm. Select the channel you want and ensure the Motion Alarm is Enabled. Then go to Action and uncheck/check on Audio. Click on Save button.
Here is a brief introduction about other options on this page.
- Send Email: You can set up email for your device on this page, it will send you an email when motion detective.
- Push Notification: A push notification will be sent to your phone if you set the push for your NVR.
- Trigger to Record: The selected channel under Trigger To Record option will begin to record when the camera you chose in Channel option triggered by motion. This option is designed for the monitoring dead ends where cannot be covered by a single camera.
Comments
0 comments
Article is closed for comments.