Applies to: All Reolink cameras/NVRs except battery-powered cameras.
You may follow the steps below to set the motion detection area for Reolink cameras via Reolink Client (Mac).
Step 1: Launch Reolink Client and log in to the camera, then go to Device Settings -> Alarm->Motion->Area page.
Step 2: Check the Enable box and drag the mouse to set the detection area, then click OK to save the settings.
Note: Motions in the area covered with white grids will be detected.
Besides Reolink Mac Client, you can also use other methods to set up motion detection area. Check details in:
Comments
0 comments
Article is closed for comments.