Here we'll guide you you set up port settings for your Reolink devices via a web browser.
Applies to: Reolink NVRs and cameras excluding the battery-powered ones, B400, D400, B800, D800, Reolink Lumus, Reolink E1, and Reolink E1 Pro.
Here is a video for your reference:
Step 1. Log in to your camera via a web browser. Click the gear icon on the top right to get to the device settings page.
Step 2. Click Network > Advanced > Port Settings > Set Up.
Step 3. The values of all the ports will show up.
For some of the models, the RTMP, HTTP, RTSP, and ONVIF ports are disabled by default. Enable them first before you configure the port values.
If the web interface of your camera is an old version, you can refer to the steps below.
Step 1. Log in to your camera via a web browser and go to the device settings page.
Step 2. Go to Network >Advanced page, then the values of all ports will show up.
Notes:
1. The range of the port number is 1~65535.
2. If you fail to see this page, you may reboot the camera and the router, and try again.