How to Configure Network General Settings via PoE NVR

This article will show you how to set up network general settings via Reolink PoE NVR with a monitor connected.

Applied to: RLN4-410 (hardware version H3MB17), RLN8-410 (hardware version H3MB02), RLN8-410-E, RLN16-410 (hardware version H3MB02/H3MB06)

Log into your Reolink PoE NVR on the monitor, and then go to Menu > Network > General.

And then you can set up the network's general settings here. There are 2 options under Network Access: Static, DHCP.

Note: This Network Access is set as DHCP by default, you can change it to Static if you want to assign a static IP address for your camera.

Helpful？

Thanks for your feedback! You can click again to cancel and feed back again.

Yes

Sorry about that. We'll be grateful if you can provide some advice.

Thank you for your feedback. Please leave your email address so that we can get in touch with you when necessary.

I've read and understood the Terms & Conditions and Privacy Policy , and I understand that Reolink will use my personal data (email) to facilitate my authentication.

submit

You have clicked too often. Please try again tomorrow.