How to Set up the Output Settings via Web Browser

You can refer to the instructions below to set up the output settings via a web browser.

Applies to: All Reolink PoE NVRs with the hardware version H3MB02/H3MB16.

Step 1. Log in to the NVR via Web Browser and go to Device Settings > Display Output page.

Step 2. You can change the output options on this tab, and click OK. The NVR will restart after you change the resolution setting.

Helpful？

Thanks for your feedback! You can click again to cancel and feed back again.

Yes

Sorry about that. We'll be grateful if you can provide some advice.

Thank you for your feedback. Please leave your email address so that we can get in touch with you when necessary.

I've read and understood the Terms & Conditions and Privacy Policy , and I understand that Reolink will use my personal data (email) to facilitate my authentication.

submit

You have clicked too often. Please try again tomorrow.