Here we'll guide you to quickly change the encode settings for Reolink cameras via a web browser.

Applies to: All Reolink Cameras (exclude battery-powered cameras, Reolink Lumus, Reolink E1, and Reolink E1 Pro).

Step 1. Log in to your camera via a web browser. Click the gear icon on the top right to get to the device settings page.

log-in-on-IE-browser.png

Click_settings_icon_web.png

Step 2. Click Camera > Stream. Then you can configure the Resolution, Frame Rate, Max Bitrate, etc. for the camera. 

encode_settings_new.png

For some of the models, you can also set up Interframe Space and Frame Rate Mode.

iframe%2Bauto_frame_rate.png

If the web interface of your camera is an old version, you can refer to the steps below. 

Step 1. Log in to your camera via web browser and go to the device settings page. 

Step 2. Go to Device Settings > Recording Encode page.

Recording Encode Page

Note: The Record Audio can be enabled only for devices that support this function.

Step 3. Change the video parameters, then click the OK button to save the settings.

Note: If you changed the resolution parameter, the camera would reboot after you save the settings.

You may also set up the encode settings by using other methods. Check details in: