How to Set up Patrol via PoE NVR

This article shows you how to set up a patrol route for your camera via NVR with a monitor connected.

Applies to: RLC-423, RLC-423W, RLC-423WS, RLC-423S, RLC-523WA, RLC-823A, RLC-823A 16X

Step 1. Enter the PTZ control panel to click the Patrol button.

Step 2. Check the No. box to choose presets you need in the patrol path, then click Set to configure its Duration and Speed.

Note:

• Preset Name: Select one position set in Preset.
• Duration: Set the duration time that the camera will stay at this position.
• Speed: Set the speed turning to the next position.

Step 3. After setting up all the preset positions you need, click Add to save the settings, and the setup of the patrol path is completed. Now you can click Start to start the patrol then click OK to exit the page.