How to Use Tour via Reolink PoE NVR

To check the monitoring image of different cameras on Reolink PoE NVR, you may need to switch the screens continuously, or you can refer to the following steps to easily set the cameras on tour.

Applies to: RLN4-410 (hardware version H3MB17), RLN8-410 (hardware version H3MB02), RLN8-410-E, RLN16-410 (hardware version H3MB02/H3MB06)

Step 1. Log in to your PoE NVR on the monitor, then go to the Menu > Display > Output page to set the Tour Time as you need.

Step 2. Select any split (less than the total number of the cameras connected to the NVR) and click on the Tour icon to start/stop the tour of the pages.

Tour

For example, if you select 4-camera split and set the Tour Time to 1 min, the monitor will display one camera image for 1 min, then turn to the next page, and so on.

Helpful？

Thanks for your feedback! You can click again to cancel and feed back again.

Yes

Sorry about that. We'll be grateful if you can provide some advice.

Thank you for your feedback. Please leave your email address so that we can get in touch with you when necessary.

I've read and understood the Terms & Conditions and Privacy Policy , and I understand that Reolink will use my personal data (email) to facilitate my authentication.

submit

You have clicked too often. Please try again tomorrow.