This article intends to show you how to set a patrol route for your camera via the Reolink App. Once set up, the camera will patrol the preset points at the speed and with the stay time specified by you.
Applies to: RLC-423, RLC-423W, RLC-523WA, RLC-823A, and RLC-823A 16X.
You may refer to the following steps to configure the patrol route for your camera via Reolink App. Please note that you must set up presets for your camera before setting up a patrol route.
Step 1. Launch the Reolink App and enter the live-view page of your camera. Tap the PTZ icon, and then tap the Patrol icon as shown in the pictures below:
Step 2. Tap the Add button on the Patrol Route page, and you could tick to choose the presets you've set in advance as the patrol points. For example, the picture below shows a patrol route of "1-2-3".
Notes:
- You can tap the
button to start the patrol, and tap the
button to suspend it.
- You can tap on the
icon of the preset points and drag to change the order of the presets. Then the patrol route will also be altered.
- The same preset can be added to the patrol route repeatedly.
- You can customize the patrol speed and stay time at each preset point (as the picture shows below). You can also delete the preset point you do not want the camera to patrol by tapping the Trash Can icon.
Comments
0 comments
Article is closed for comments.