Reolink WiFi NVR
Here is the guideline of setting motion detection recording for the camera on “Channel 1” on Reolink WiFi NVR.
Step 1. Log into your Reolink WiFi NVR. Click “Recording” >> “Schedule”. Select the Camera No.(channels) and set the time you want to enable motion detection recording (“Motion” means motion detection recording). Click “Apply” to finish setting the motion detection recording schedule.
Step 2. Click “Motion” and select the Channel (Channel1), and then check “Enable”.
Step 3. Click “Motion Detection” to set the detection areas.
You will see a page that is covered by the red grid. The areas are motion detection areas. Left click the red-grid page and drag the mouse to set up areas that you want to detect. For reducing false alarms, you can exclude the areas you don’t need motion detection.
Step 4. After you have finished setting up motion detection areas, right-click the interface to set up motion detection “Sensitivity”.
You may set the sensitivity higher at night and lower the value in the daytime to reduce false alarms. Click “Apply” to save the settings of “Sensitivity”.
Step 5. Right-click to back to the “Motion” page and click “Schedule” to select which period of time (have to cover the motion recording schedule) you would like to receive alerts when there are motion events, then click “Apply” in this page and click “Apply” in “Motion” page to save.
Please note that all the settings mentioned above are only for channel 1. If you want the same configurations to be applied to other channels (cameras), please use “Copy To” to apply the settings to other channels (cameras).
For set motion recording on the specified channel, you have to match all following conditions:
- Set the motion recording in the channel‘s recording schedule.
- Enable the motion for the channel and the motion schedule have to cover the motion recording schedule.