This article guides you on how to reset your Reolink Argus PT series camera. Depending on your camera’s hardware version, the reset method may vary.

Reset Using the Reset Hole

Applies to: Argus PT, Argus PT 2K, Argus PT Lite, Argus Series B420, Argus PT Ultra (Hardware version: BIPC_560MIX16M35SD938MP)

  1. Switch on the camera.

  2. Rotate the lens to locate the reset hole, which is near the microSD card slot.

  3. Insert a reset pin and press and hold until you hear a short beep or the voice prompt “Please release the reset button”.

  4. Release the pin. The camera is now factory reset.

reset hole argus pt

Also, here is a video for your reference:

Reset Using the Power Button

Applies to: Argus PT Ultra (Hardware version: BIPC_NT2BNO28MPW4SD15V5)

  1. Turn on the camera by pressing and holding the power button for 2 seconds.

  2. Press the power button three times in a row to perform a hard reset.

reset button argus pt

Initial Setup

After resetting, if you hear a startup prompt (such as a welcome message, a beep, or repeated voice guidance), it means the camera has been successfully reset and is now waiting for configuration.
There is no need to reset again. Use your phone to scan the square QR code on the camera body or manually enter its UID (located below the square QR code, starting with 9527) to complete the setup as instructed.

FAQ

Contacting Support

If you continue to experience difficulties after following these troubleshooting steps, do not hesitate to click "Submit a request" below to contact Reolink Support Team. When submitting a support request, include detailed information about the troubleshooting steps you have taken and the outcomes. This information will assist the support team in diagnosing and resolving your case more efficiently.