Applies to: All Reolink PoE NVRs.

You may follow the steps below to configure the output settings via Reolink Client.

Note: To change the output resolution of the cameras, make sure the NVR firmware version is 161209 or newer and client version is or above.

Step 1. Log in to the NVR via Reolink Client and go to Device Settings -> DisplayOutput.

Device Settings

Step 2. You may change the output setting accordingly. You may refer to this artichle for more details of the output settings.

Note: The NVR will restart after you change the resolution settings.

Output Settings

Besides Reolink Windows Client, you can also set up the output settings by using other methods. Check details in: