Applies to: All Reolink PoE NVRs
You may follow the steps below to configure the output settings via Reolink Client.
Note: To change the output resolution of the camere, make sure the NVR firmware version is 161209 or above and client version is 126.96.36.199 or above.
Step 1. Log in to the NVR via Reolink Client and go to Device Settings >> DisplayOutput.
Step 2. You may change the output setting accordingly. You may refer to this artichle for more details of the output settings.
Note: The NVR will restart after you change the resolution settings.