Follow the steps below to use the pan/tilt/zoom function of Reolink cameras via Reolink NVRs.

Applies to: RLN8-410, RLN16-410, RLN36 and RLN12W.

Notes:

1. To confirm if your camera can support pan/tilt/zoom, you can have a look at Introduction to PTZ.

2. Reolink NVRs have two kinds of the user interface, you can confirm the user interface of your NVR according to the hardware version, refer to Introduction to Hardware Versions of Reolink NVRs.

For NVRs with New UI:

Step 1. Log in to your NVR on the monitor, click the Live View window of the camera and click PTZ

PTZ.png

Step 2. Control the pan/tilt/zoom function on the PTZ panel. 

PTZ panel.png

Note: Features on the PTZ panel will vary from camera models. 

For NVRs with Old UI:

Step 1. Log in to your NVR on a monitor, then tap on the Live View window of the camera and click the PTZ Icon icon to open the PTZ panel.

Open PTZ Panel

Step 2. Use pan/tilt/zoom function by setting options in the PTZ panel.

  • Click the directional arrows on the pan/tilt wheel to manually control the direction of the camera.
  • Click the button in the middle to start an automatic scan, then tap on it again to stop it in the direction you prefer.
  • Click "+" icon to zoom in and click "-" icon to zoom out the camera image.

ptz.png