Applies to: All Reolink cameras (exclude battery-powered cameras).
Step 1. Click “Toolbar” “Configure” “Camera Install” and then you will see how the camera installs windows.
Step 2. Click “Add Camera” and then input the server IP (camera IP address, you can use Reolink Client to find it).
Http port: Default is 80.
Input “username” and “password”.
From brand area, choose “Protocol” at bottom list.
From the device column, choose “RTSP over UDP”.
Step 3. Now you need to input the RTSP command. You can use “Dual Stream” or single stream (examples are as follows).
Main Stream: rtsp://IP address/h264Preview_01_main
Sub Stream: rtsp://IP address/h264Preview_01_sub
Step 4. On protocol windows, input “Port” 554, and click “Apply”.
Step 5. You will find the camera on the device list. Click “Status” grey dot. When it changes into green, you will find the device shown on the VMS.