How to Set up Action via Reolink PoE NVR

Follow the steps below to configure the different kinds of alarms including buzzer, push, and email on the Action page for your cameras via Reolink PoE NVR on the monitor.

Applies to: RLN4-410 (hardware version H3MB17), RLN8-410 (hardware version H3MB02), RLN8-410-E, RLN16-410 (hardware version H3MB02/H3MB06)

Step 1. Go to Menu > Alarm > Motion page, select the channel (camera) you want to set up, then check Enable box and click on Action Set.

Motion Page

Step 2. Check Channel boxes for the cameras you would like to enable Trigger Recording for (at least including the channel you have selected in Step 1), then click Apply to save the settings for Action. Action Page

Helpful？

Thanks for your feedback! You can click again to cancel and feed back again.

Yes

Sorry about that. We'll be grateful if you can provide some advice.

Thank you for your feedback. Please leave your email address so that we can get in touch with you when necessary.

I've read and understood the Terms & Conditions and Privacy Policy , and I understand that Reolink will use my personal data (email) to facilitate my authentication.

submit

You have clicked too often. Please try again tomorrow.