Applies to: All Reolink cameras and NVRs
1. Before you start, please scan the QR code to download and install the latest version of Reolink App to your phone and make sure your devices are successfully connected to the internet.
2. If your device has not been set up yet, please refer to initial setup for Reolink Cameras via Reolink App.
3. All Reolink cameras and NVRs, either in the same location or at different locations, can be added into the same Reolink APP and there is no limitation about the camera quantity.
You follow the steps below to access the device that's already been set up.
Step 1. Launch Reolink App, click "+" on the top right of the Devices page to add a new device.
Step 2. For local access, we recommend you to add device by scanning the QR code.
Note: You may tap Light to enable flash light when setting up in a dark environment.
For remote access, please click enter to input the information manually and access your device via UID or IP/DDNS.
Step 3. Click WiFi Already Configured to view a camera that's already been set up (this step is only for battery-powered cameras except for Reolink Go).
Step 4. Input the username and the password, then click Login to access your device.
Note: The default User Name is admin default Password is blank. If you have changed and forgotten the password, you may reset your device.
Comments
0 comments
Article is closed for comments.