This article intends to guide you on how to install RLC-823A 16X on the wall. Please follow the steps below.

Step 1. Run the three-terminal wire through the bracket, and fasten the other end of the wire rope anchor to the bracket.


Step 2. Loosen a screw on the top of the camera and secure one end of the wire rope anchor to the camera.


Step 3. Place the mounting template on the desired position of the wall and drill holes accordingly.


Step 4. Install two screws into the upper two holes and hang the bracket over them.


Step 5. Install another two screws into the lower two holes to secure the bracket.


Step 6. Screw the end of the bracket and secure the camera to it.


Done! Now you can control the camera to pan and tilt via Reolink App or Client to change the camera's viewing direction.