If you are in a country or region that uses DST(Daylight Saving Time) during the summer months, you can set your camera to use DST to avoid confusion.

Applies to: All Reolink cameras and NVRs except for batter-powered cameras, E1, E Series E320, E1 Pro, E Series E330, and Lumus, Lumus Series E430.

Step 1. Input the IP Address of your camera on a web browser and log in to your camera.

See how to find the IP address of your camera.

1._log_in_via_web_browser.png

Note: Make sure your PC is connected to the same router as your camera.

Step 2. Click the Device Settings gear icon on the top right corner.

2._click_device_settings_icon.png

Go to System > Date & Time. Click the time settings icon below.

3._date_and_time_settings.png

Step 3. Scroll down on the page and turn on the DST button to enable DST. Now you need to configure each parameter for DST. After finishing the settings, make sure you click Confirm.

  • Offset refers to the number of hours added to the current time. You can choose 1 hour or 2 hours.
  • Start Time refers to when the DST settings take effect. You can specify the month, week, day, hour, minute, and second.
  • End Time refers to when the DST settings stop. Then DST will be disabled automatically. 

4._enable_DST.png

Step 4. Check if the Modified Time is consistent with your settings. Then click Confirm.

5._confirm_dst_settings.png

Step 5. Check if the Current Time has been changed accordingly.

check_current_time.png

Note: If you don't want the camera to observe summertime anymore, please turn off the DST button in Step 3.