When you preview your camera via a web browser, you can change the stream mode to get a clear or fluent live view of your camera.

Applies to: All Reolink cameras and NVRs except for battery-powered cameras, E1, E1 Pro, Lumus, and add-on cameras. 

Step 1. Input the IP Address of your camera on a web browser and log in to your camera.

See how to find the IP address of your camera.

1._log_in_via_web_browser.png

Note: Make sure your PC is connected to the same router as your camera.

Step 2. Click the Low button at the bottom left corner of the Preview page.

You can switch between Fluent/Balanced/Clear stream mode based on your needs and the network condition. 

change_stream_mode_on_web.png

Notes:

1. The web interface may vary according to different camera modes.

2. For 8MP/12MP cameras, the highest resolution of the Clear mode is not supported currently.
Accessing cameras via web browser is achieved by RTMP. The highest resolution of the mainstream of our 8MP/12MP cameras is in H.265 format, however, since RTMP does not support H.265 format, the 8MP/12MP cameras cannot be viewed under Clear mode in highest resolution via web browser.

3. If you are previewing TrackMix WiFi/PoE or RLC-81MA, you can view the two lenses one by one by changing the stream mode:

change_stream_on_web_for_trackmix_poe.png

  • Click Track to see the image of the telephoto (tracking) lens.
  • Click Low to enter the fluent stream image of the wide-angle lens.
  • Click High to enter the clear stream mode of the wide-angle lens. (not supported currently)