How to Power on Reolink NVRs

This article intends to show you how to power up the Reolink NVRs properly. Please follow the instructions below.

Applies to: RLN8-410, RLN16-410, and RLN36.

Step 1. Plug the DC adapter connector into the power port of the NVR.

Step 2. Plug the DC adapter into the power outlet.

Step 3. Turn on the power switch.

4.power_on_NVR.png

Note: For NVR with the hardware version of H3MB02 and H3MB16, there will be no power switch on your NVR. Your NVR will be powered up directly at Step 2.

Helpful？

Thanks for your feedback! You can click again to cancel and feed back again.

Yes

Sorry about that. We'll be grateful if you can provide some advice.

Thank you for your feedback. Please leave your email address so that we can get in touch with you when necessary.

I've read and understood the Terms & Conditions and Privacy Policy , and I understand that Reolink will use my personal data (email) to facilitate my authentication.

submit

You have clicked too often. Please try again tomorrow.