How to Sync Brightness of the Two Lenses via Reolink Client (New Client)

This article will guide you through synchronizing the brightness for the two lenses via the Reolink Client.

Applies to: Reolink Duo, Duo 4G, Duo WiFi, and Duo PoE

For Reolink Duo series cameras, you could adjust the brightness for the two lenses respectively. But if you hope one lens will always be as bright as the other, you can also make it within seconds. Here is how to synchronize them on Reolink Client.

Step 1. Launch Reolink Client. Click the Device Settings gear icon at the right end of the device tab.

1.click_device_settings.png

Step 2. Go to Display > Advanced. Then enable Sync Brightness.

2.go_to_display-advanced.png

3.enable_sync_brightness.png

Done! Now, when you adjust the brightness of any one lens, the other will follow and adjust it automatically. Disable it if you don't want to sync the brightness of two lenses anymore.

Note: Each time you toggle this switch, the camera will reboot.

Helpful？

Thanks for your feedback! You can click again to cancel and feed back again.

Yes

Sorry about that. We'll be grateful if you can provide some advice.

Thank you for your feedback. Please leave your email address so that we can get in touch with you when necessary.

I've read and understood the Terms & Conditions and Privacy Policy , and I understand that Reolink will use my personal data (email) to facilitate my authentication.

submit

You have clicked too often. Please try again tomorrow.