If you have ordered the Reolink Duo Floodlight WiFi or if you are interested in this camera model, and want to get some basic information about this product before putting it in use or placing the order, you may refer to the below introduction.

This article includes the following 4 parts which will help you quickly understand the use and working principles of the camera:

Part 1: Unboxing

Part 2: Product Overview

Part 3: Installation 

Part 4: Initial Setup

Unboxing for Reolink Duo Floodlight WiFi

Here is what is included in the box:

What's in the box of Duo Floodlight WiFi.png

Product Overview

You may find detailed information about the structure and components of the camera here.

structure of duo floodlight wifi.png

  1. Lens
  2. IR LED
  3. Floodlight
  4. Antenna
  5. Daylight Sensor
  6. Mic

structure of duo floodlight wifi bottom.png

  1. Micro SD Card Slot
  2. Reset Button
  3. Speaker

components of duo floodlight wifi.png

  1. Power
  2. Network
  3. Waterproof Lid

duo floodlight angle.png

duo floodlight size.png



Fix the Floodlight to the Camera

Fix the floodlight to the camera.png

1. Screw the floodlight to the camera.
2. Connect the wire from the floodlight to the wire from the camera. Make sure the side of
the wire from the floodlight with an arrow mark on it faces the LAN port, as shown in the
3. Tuck the wires into the mounting bracket.

Mount the Camera to the Wall

mount the camera to the wall.png

1. Drill holes in accordance with the mounting template.
2. Secure the mounting plate to the wall with two screws.
3. Connect the steel wire rope in the mounting bracket to the mounting plate,
and hang the camera on the mounting plate.
4. Drill into the wall in accordance with the hole on the mounting bracket. Lock the camera in
position with a screw.

NOTE: Use the drywall anchors included in the package if needed.

Installation Tips

  • Do not face the camera toward any light sources.
  • Do not point the camera toward a glass window. Or, it may result in poor image quality
    because of the window glare by infrared LEDs, ambient lights, or status lights.
  • Do not place the camera in a shaded area and point it towards a well-lit area. Or, it may
    result in poor image quality. To ensure the best image quality, the lighting condition for both the
    camera and the captured object shall be the same.
  • To ensure better image quality, it’s recommended to clean the lens with a soft cloth from
    time to time.
  • Make sure the power ports are not directly exposed to water or moisture and not blocked
    by dirt or other elements.
  • With IP waterproof ratings, the camera can work properly under conditions like rain and
    snow. However, it doesn't mean the camera can work underwater.
  • Do not install the camera at places where rain and snow can hit the lens directly.
  • The camera may work in extremely cold conditions as low as -25°C. Because when it is
    powered on, the camera will produce heat. You may power on the camera indoors for a few
    minutes before installing it outdoors.
  • Try to keep the left lens level with the right lens.

Micro SD Card Installation

Please refer to the below steps to install the SD card on your camera.

Step 1. Use a screwdriver to unscrew the cover from the camera.

Step 2. Insert a micro SD card, please use your fingernail (or use the provided reset needle) to push the micro SD card in until you feel it is locked, and you will hear a click sound and the micro SD card will not pop out if the camera is inserted in properly.


Initial Setup

To set up the camera, you need to switch on the camera and then finish the initial setup via both Reolink App and the Client.