If you are interested in E1 or already have ordered it, check out this article to see what you can get in the box and how to start using it.

Part 1: Unboxing for E1

Part 2: Product Overview

Part 3: Installation 

Part 4: Initial Setup

Unboxing for E1

You can refer to the picture below to check what is included in the box for E1.

E1_unboxing.png

Product Overview

You may find detailed information about the structure and components of the camera here.

E1-1.png

  1. Daylight Sensor
  2. 8 IR LEDs
  3. Lens
  4. Status LED
  5. Built-In Mic
  6. Reset Button
  7. Micro SD Card Slot

E1-2.png

  1. LAN Port
  2. Speaker
  3. Power

For more specifications of the E1, please refer to Specifications - E1

Installation

Mounting

Below are the instructions to mount the E1 camera.

Step 1. Drilling two screw holes on the wall according to the mounting hole template.

Step 2. Insert the two plastic anchors into the holes in the wall.

Step 3. Secure the base unit in place by tightening the screws into the plastic anchors.

Installation_1.png

Step 4. Align the camera with the bracket, then turn the camera unit clockwise to lock it in position.

Installation_2.png

Note:
1. Turn the camera anticlockwise to remove it from the wall.
2. In case your camera is mounted upside down, the picture will need to be rotated as well.  Please go to Device Settings > Display interface, then click Rotation to adjust the image.

Micro SD Card Installation

Step 1. Raise up the lens to find the Micro SD card slot.

Step 2. Insert the Micro SD card into the card slot in the correct direction.

Install_the_Micro_SD_card.png

Note: Please use your fingernail or something sharp like the reset pin to push the Micro SD card in until you feel that it's locked or you hear a "click".

Initial Setup

You may set up the camera on your wireless network via both Reolink App and Client. To do this, please refer to the articles below.

  • On Reolink App

    • Step 1. Download the App on your phone and start the setup process.
      Step 2. Tap on the "+" icon in the top right corner to start the initial setup.
      Step 3. Scan the QR code at the back of the camera or enter the 16-digit UID number to add it.
      Step 4. Select "Wi-Fi Not configured".
      Step 5. Enter the Wi-Fi password of the selected Wi-Fi network and tap Next.
      Step 6. Use the camera to scan the QR code generated on the phone.
      Step 7. After scanning, there will be a short beep sound. The camera will try to connect to the router.
      To get more information, please check: How to Do Initial Setup for Reolink E1 Series Cameras/Argus Series Cameras/ Reolink Lumus via Reolink App

  • On Reolink Client

    • Step 1. Download the Client on your PC and start the setup process.
      Step 2. Tap on the "+" icon in the top left corner to start the initial setup.
      Step 3. Enter the 16-digit UID number to add the camera.
      Step 4. Select "Connect to Wi-Fi".
      Step 5. Enter the Wi-Fi password of the selected Wi-Fi network and tap Next.
      Step 6. Use the camera to scan the QR code generated on the PC.
      Step 7. After scanning, there will be a short beep sound. The camera will try to connect to the router.
      For more details, please refer to: How to Do Initial Setup for Reolink E1 Series Cameras / Reolink Lumus via Reolink Client (New Client)